Physical sciences

A major societal issue of disposal and environmental pollution is raised by the enormous and fast-growing production of single-use polyethylene terephthalate (PET) bottles, especially in developing countries. To contribute to the problem solution, an original route to recycle PET in the form of value-added environmentally friendly thermoplastic composites with banana fibres (Musa acuminata) has been developed at the laboratory scale. Banana fibres are a so far undervalued by-product of banana crops with great potential as polymer reinforcement. The melt-processing constraints of commercial PET, including used bottles, being incompatible with the thermal stability limits use of natural fibres; PET has been modified with bio-sourced reactants to produce co-polymers with moderate processing temperatures below 200 °C. First, commercial PET were partially glycolyzed with 1.3-propanediol to produce co-oligomers of about 20 repeating units, which were next chain extended with succinic anhy...

The propagation speeds of premixed n-butane–air mixtures (2.0–5.7 vol%) were investigated under various initial conditions (pressures of 0.4–1.2 bar; temperatures of 289–500 K). The study consists of both, experimental measurements using two different enclosures (a sphere and a cylinder) and kinetic modeling via a dedicated computing program. The propagation speeds of premixed n-butane–air mixtures were obtained via the adiabatic model of flame propagation, which allows us to obtain these important parameters using the normal burning velocities and expansion coefficients. The expansion coefficients were calculated using thermodynamic data as the ratio of burnt to unburnt gas densities, assuming that an equilibrium was established in the flame front. The propagation speeds obtained based on the experimental burning velocities were analyzed for comparison with the computed velocities. Finally, the dependence of the propagation speed on the initial pressure and temperature was discussed.

Willow wood presents a real interest for biomass pyrolysis due to its fast growth, renewability, and high energy density. Following the pyrolysis of willow wood in an inert atmosphere, a multi-fuel gaseous mixture was obtained, with the following composition (by volume): 38.20% CO/21.87% H2/17.44% CH4/1.15% O2/17.15% CO2/4.19% N2. The propagation of laminar premixed flames in these multifuel mixtures with air was investigated numerically for initial temperatures from 298 to 500 K, initial pressures from 1 to 20 bar, and fuel equivalence ratios between 0.60 and 2.00. The combustion of these gaseous mixtures as free laminar premixed flames was simulated by means of the INSFLA package and an extended reaction mechanism with 592 elementary reactions and 53 species. The modelling of the gas-phase combustion delivered several important parameters: the laminar burning velocities, Su, the maximum flame temperatures, Tfl,max, the flame front thicknesses, dfl, and the peak concentrations of t...

The present work aims to evaluate the performance of the constant-volume method by several sets of experiments carried out in three different closed vessels (a sphere and two cylinders) analyzing the obtained results in order to obtain accurate laminar burning velocities. Accurate laminar burning velocities can be used in the development of computational fluid dynamics models in order to design new internal combustion engines with a higher efficiency and lower fuel consumption leading to a lower degree of environmental pollution. The pressure-time histories obtained at various initial pressures from 0.4 to 1.4 bar and ambient initial temperature were analyzed and processed using two different correlations (one implying the cubic low coefficient and the other implying the burnt mass fraction). The laminar burning velocities obtained at various initial pressures are necessary for the realization of a complete kinetic study regarding the combustion reaction and testing the actual react...

In this study, experimental measurements in a spherical combustion bomb were performed in order to investigate the flame propagation in N2-diluted CH4-N2O mixtures with stoichiometric equivalence ratio, at several initial pressures (0.5–1.75 bar) and ambient initial temperatures. Methane was chosen as a test-fuel, since it is the main component of natural gas, a fuel often used as a substitute to gasoline in engines with internal combustion and industrial plants. The method approached in this study is based on a simple examination of the cubic law of pressure rise during the early (incipient) period of flame propagation. The incipient stage defined by a pressure rise equal or smaller than the initial pressure, was divided into short time intervals. The burnt mass fractions (obtained using three different Equations) and flame radii at various moments of the flame propagation in the course of the incipient stage were calculated. The cubic law coefficients and corresponding laminar bur...

The laminar burning velocities and propagation speeds of stoichiometric n-butane-air mixture were obtained for outwardly propagating spherical flames by measurements of pressure rise during the early stage of propagation in a spherical vessel. The experiments were carried out at various initial pressures within 0.3 and 1.2 bar, and various initial temperatures within 298 and 423 K. The experimental laminar burning velocities were compared with those provided by the detailed kinetic modelling based on Warnatz mechanism for combustion of C1-C4 hydrocarbons, using INSFLA package. The baric and thermal coefficients of laminar burning velocities, calculated from their dependence on initial temperature and pressure, were compared with coefficients characteristic for other fuel-air mixtures. The overall activation parameters (reaction order and activation energy) are reported and discussed in comparison with similar data characteristic for alkane-air flames.